The roof is dripping, the ceiling is turning brown – and the plumber is only coming next week.
A slow drip at the pipe connection or a damp spot on the basement wall quickly turns into an expensive damage. AquaGuard Pro combines resin and polyurethane into a flexible plastic layer that chemically bonds to the substrate – on concrete, PVC, metal, wood, brick, and painted masonry. Within 24 hours, the area is completely waterproof without a craftsman needing to visit.
Advantages
- No further water damage: The brown ceiling stain stops growing because the sealant penetrates directly into the crack and does not peel off during the next frost or rain shower.
- No more scheduling of handyman appointments: Apply, let dry, done – three steps without tools, primer, or compressor, so your evening stays free.
- No more doubts whether the sealing holds in winter: The cured layer expands and contracts with the substrate at temperature fluctuations from -20 °C to +80 °C, instead of tearing at the edges like rubber spray.
Specifications
- Content: 100 ml / 3.53 fl oz
- Scope of delivery: Can + 9.8 cm application brush
- Drying time: 2–4 hours touch dry, 24 hours fully cured
- Temperature resistance: -20 °C to +80 °C (-4 °F to +176 °F)
- Surfaces: Metal, wood, concrete, PVC, brick, painted masonry
- Formula: Resin + polyurethane + hardener
Application
- Prepare: Clean the leak area and dry it as much as possible – dust and moisture prevent adhesion.
- Apply: Shake the can vigorously for 30 seconds, spray evenly onto the crack, and work in with the supplied brush for wider joints.
- Let cure: Leave the area untouched for 24 hours – after that, it is fully waterproof and load-bearing.
Pro tip: For active drips, first wipe the area as dry as possible with a cloth, then spray immediately and use the brush to press the material deep into the gap – this significantly speeds up the initial seal.